Power button with fingerprint reader
Removing the power button with fingerprint reader
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
NOTE: Applicable only for computers that are shipped with fingerprint reader.
Prerequisites
1. Remove the base cover.
2. Remove the battery.
3. Remove the solid-state drive/Intel Optane.
4. Remove the fan.
5. Remove the heat sink.
6. Remove the wireless card.
7. Remove the system board.
NOTE:
When removing and replacing the power button with fingerprint reader, do not remove the heat sink from the
system board.
Procedure
1. Remove the two screws (M2x3) that secure the power button with fingerprint reader to the palm-rest and keyboard assembly.
2. Lift the power button off the palm-rest and keyboard assembly.
3. Peel the fingerprint-reader cable off the palm-rest and keyboard assembly.
4. Lift the power button with fingerprint reader, along with the fingerprint-reader board and its cable, off the palm-rest and keyboard
assembly.
56
Removing and installing components
To Next Page
Loading...
