Replacing the fan
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1 Place the fan on the palm-rest assembly and align the screw holes on the fan with the screw holes on the keyboard shield.
2 Replace the two screws (M2x3) that secure the fan to the keyboard shield.
3 Connect the fan cable to the system board.
4 Route the I/O-board cables through the routing guides on the fan.
5 Slide the I/O-board cable into the connector on the system board and close the latch to secure the cable.
6 Adhere the tape that secures the I/O-board cable to the system board.
18
Replacing the fan 31
To Next Page
Loading...
