Removing the display assembly
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the wireless card.
Procedure
1 Turn the computer over and open the display to 180-degree angle.
2 Place the computer on a at surface with the display facing down.
CAUTION
: Place the computer on a soft and clean surface to avoid scratching the display.
3 Peel o the tapes that secure the display cable and touch-screen board cable (optional) to the system board.
4 Open the latches and disconnect the display cable and the touch-screen board cable (optional) from the system board.
5 Remove the antenna cables from the routing guides on the palm-rest assembly.
6 Remove the seven screws (M2.5x5) that secure the display assembly to the palm-rest assembly.
7 Lift the display assembly o the palm-rest assembly.
27
44 Removing the display assembly
To Next Page
Loading...
