Hard Drive | 23
Replacing the Hard Drive
Procedure
1 Align the screw holes on the hard-drive cage with the screw holes on the
hard drive.
2 Replace the screws that secure the hard-drive cage to the hard drive.
3 Connect the power and data cable to the connector on the hard-drive assembly.
4 Place the hard-drive assembly on the chassis and slide the hard-drive assembly
into place. Ensure that the slots on the hard-drive cage are secured under the tabs
on the chassis.
5 Replace the screws that secure the hard-drive assembly to the chassis.
Postrequisites
1 Replace the back cover. See "Replacing the Back Cover" on page 20.
2 Replace the stand. See "Replacing the Stand" on page 18.
3 Replace the stand cover. See "Replacing the Stand Cover" on page 16.
4 Follow the instructions in "After Working Inside Your Computer" on page 13.
book.book Page 23 Monday, April 16, 2012 3:04 PM
To Next Page
Loading...
