Dell Inspiron One 2020 - Replacing the Fan

56 | Fan
Procedure
1 Disconnect the fan cable from the connector (FANC1) on the system board.
2 Remove the fan cable from the routing guide on the fan.
3 Remove the screws that secure the fan to the chassis.
4 Lift the fan along with its cable away from the chassis.
Replacing the Fan
Procedure
1 Align the screw holes on the fan with the screw holes on the chassis.
2 Replace the screws that secure the fan to the chassis.
3 Route the fan cable through the routing guide on the fan.
4 Connect the fan cable to the connector (FANC1) on the system board.
Postrequisites
1 Replace the system-board shield. See "Replacing the System-Board Shield" on
page 36.
2 Replace the back cover. See "Replacing the Back Cover" on page 20.
3 Replace the stand. See "Replacing the Stand" on page 18.
4 Replace the stand cover. See "Replacing the Stand Cover" on page 16.
5 Follow the instructions in "After Working Inside Your Computer" on page 13.
1 screws (2) 2 fan
3 fan cable
1
2
3
book.book Page 56 Monday, April 16, 2012 3:04 PM