TV-Tuner Card (Optional) | 43
Replacing the TV-Tuner Card
Procedure
CAUTION: To avoid damage to the TV-tuner card, ensure that there are no cables
under the TV-tuner card.
1 Align the notch on the TV-tuner card with the tab on the system-board connector.
2 Insert the TV-tuner card at a 45-degree angle into the system-board connector.
3 Press the other end of the TV-tuner card down and replace the screw that secures
the TV-tuner card to the system-board connector.
4 Connect the TV-tuner-card cable to the connector on the TV-tuner card.
Postrequisites
1 Replace the system-board shield. See "Replacing the System-Board Shield" on
page 36.
2 Replace the back cover. See "Replacing the Back Cover" on page 20.
3 Replace the stand. See "Replacing the Stand" on page 18.
4 Replace the stand cover. See "Replacing the Stand Cover" on page 16.
5 Follow the instructions in "After Working Inside Your Computer" on page 13.
book.book Page 43 Monday, April 16, 2012 3:04 PM
To Next Page
Loading...
