Speakers | 53
Replacing the Speakers
Procedure
1 Align the screw holes on the speakers with the screw holes on the middle frame.
2 Replace the screws that secure the speakers to the middle frame.
3 Route the speakers cable through the routing guides.
4 Connect the speakers cable to the connector (SPEAKER) on the system board.
Postrequisites
1 Replace the system-board shield. See "Replacing the System-Board Shield" on
page 36.
2 Replace the B-CAS card. See "Replacing the B-CAS Card" on page 28.
3 Replace the back cover. See "Replacing the Back Cover" on page 20.
4 Replace the stand. See "Replacing the Stand" on page 18.
5 Replace the stand cover. See "Replacing the Stand Cover" on page 16.
6 Follow the instructions in "After Working Inside Your Computer" on page 13.
book.book Page 53 Monday, April 16, 2012 3:04 PM
To Next Page
Loading...
