Dell Inspiron One 2020 - Replacing the System-Board Shield

36 | System-Board Shield
3 Disconnect the antenna-in connector cable from the connector on the
TV-tuner card.
4 Remove the antenna-in connector. See "Removing the Antenna-In Connector" on
page 37.
Replacing the System-Board Shield
Procedure
1 Replace the antenna-in connector. See "Replacing the Antenna-In Connector" on
page 38.
2 Connect the antenna-in connector cable to the connector on the TV-tuner card.
3 Turn the system-board shield over and align the screw holes on the
system-board shield with the screw holes on the chassis.
4 Replace the screws that secure the system-board shield to the chassis.
Postrequisites
1 Replace the back cover. See "Replacing the Back Cover" on page 20.
2 Replace the stand. See "Replacing the Stand" on page 18.
3 Replace the stand cover. See "Replacing the Stand Cover" on page 16.
4 Follow the instructions in "After Working Inside Your Computer" on page 13.
1 system-board shield 2 antenna-in connector cable
3 TV-tuner card
3
2
1
book.book Page 36 Monday, April 16, 2012 3:04 PM