Installing base cover
If the system is shipped with M.2 SSD perform the following steps.
1 Toe in the base cover front edge into the system.
2 Press the edges of the cover until it clicks into place.
3 Replace the M2.5x7 screws to secure the base cover to the computer.
4 Install the microSD card
5 Follow the procedure in After working inside your computer.
Battery
Removing battery (optional)
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a microSD card
b base cover
3 To remove the battery:
a Disconnect the battery cable from the connector on the system board [1,2].
b Remove the M2.0x3.0 screws that secure the battery to the computer [3].
c Lift the battery away from the computer [4].
10
Removing and installing components
To Next Page
Loading...
