Dell Latitude 3180 - Accessing System Setup; General screen options; System Configuration screen options

• Change the system conguration information after you add, change, or remove any hardware in your computer.
• Set or change a user-selectable option such as the user password.
• Read the current amount of memory or set the type of hard drive installed.
Before you use System Setup, it is recommended that you write down the System Setup screen information for future reference.
CAUTION: Unless you are an expert computer user, do not change the settings for this program. Certain changes can cause your
computer to work incorrectly.
Accessing System Setup
1 Turn on (or restart) your computer.
2 After the white Dell logo appears, press F2 immediately.
The System Setup page is displayed.
NOTE: If you wait too long and the operating system logo appears, wait until you see the desktop. Then, shut down or
restart your computer and try again.
NOTE: After the Dell logo appears, you can also press F12 and then select BIOS setup.
General screen options
This section lists the primary hardware features of your computer.
Option
Description
System Information This section lists the primary hardware features of your computer.
• System Information: Displays BIOS Version, Service Tag, Asset Tag, Ownership Tag, Ownership Date,
Manufacture Date, Express Service Code, the Signed Firmware update—enabled by default
• Memory Information: Primary Hard Drive, SATA, Displays Memory Installed, Memory Available, Memory Speed,
Memory Channels Mode, Memory Technology
• Processor Information: Displays Processor Type, Core Count, Processor ID, Current Clock Speed, Minimum
Clock Speed, Maximum Clock Speed, Processor L2 Cache, HT Capable, and 64-Bit Technology
• Device Information: Primary Hard Drive, Passthrough MAC address, Video Controller, Video BIOS Version,
Video Memory, Panel Type, Native Resolution, Audio Controller, Wi-Fi Device, Bluetooth Device
Battery Information Displays the battery status health and whether the AC adapter is installed.
Advanced Boot
Options
• Enable Legacy Option ROMs (Enable Default)
• Enable Attempt Legacy Boot (Enable Default)
• Enable UEFI Network Stack
UEFI boot path
security
• Always, except internal HDD (System Default)
• Always
• Never
Date/Time Allows you to change the date and time.
System Conguration screen options
Option
Description
Drives Allows you to congure the SATA drives on board.
System setup options 37