Solid State Drive (SSD)
Removing M.2 Solid State Drive (SSD)
If the system is shipped with M.2 SSD perform the following steps.
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a microSD card
b base cover
c battery
3 To remove the SSD:
a Remove the M2.0x3.0 screw that secures the SSD card [1].
b Slide and lift the SSD card from the system board [2].
Installing M.2 Solid State Drive (SSD)
NOTE
: If the system is shipped with SSD perform the following steps.
1 Align the notch on the SSD card with the tab on the SSD card connector and slide the card into the slot.
2 Align the screw hole on the SSD card with the screw hole on the system board.
3 Replace the screw that secures the SSD card to the system board.
4 Install the:
a battery
b base cover
c microSD card
Removing and installing components
13
To Next Page
Loading...
