Installing display assembly
1 Place the display assembly to align with the screw holders on the computer.
2 Replace the screws that secure the display hinges to the palm-rest assembly.
3 Flip over the computer.
4 Connect the display cable to the connector on the system board.
5 Place the metal bracket over the (display cable) connector, and tighten the M2.0x3.0 screws to secure the display cable to the
computer.
6 Connect the WLAN cables.
7 Place the metal bracket, and tighten the M2.0x3.0 screw to the WLAN cable on the system board.
8 Install the:
a battery
b base cover
c microSD card
9 Follow the procedure in After working inside your computer.
Display bezel
Removing display bezel
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a microSD card
b base cover
c battery
3 Remove the hinge cap and the mylar cap that secures the display bezel to the display assembly [1,2].
Removing and installing components
23
To Next Page
Loading...
