4 To disconnect the cable:
a Disconnect coin cell battery, power connector port, and speaker cable [1, 2, 3].
b Remove the M2.0xM3.0 screws and lift the metal bracket that secure on the system board [4, 5].
5 To remove metal bracket:
a Remove the screw M2.0x3.0 and lift the metal bracket that secures the WLAN card on the system board [1, 2]
b Disconnect the WLAN cables [3].
c Remove the screws M2.0x.30 and lift the metal bracket that secures the display cable on the computer [4, 5]
Removing and installing components
19
To Next Page
Loading...
