Dell Latitude 3450 - Installing the M.2 2230 solid-state drive

About this task
NOTE: This procedure applies only to systems shipped with a M.2 2230 solid-state drive installed.
NOTE: The M.2 solid-state drive that is installed on your system depends on the configuration ordered. Supported card
configurations on the M.2 solid-state drive slot is M.2 2230 solid-state drive.
The following images indicate the location of the M.2 2230 solid-state drive and provide a visual representation of the removal
procedure.
Figure 19. Removing the M.2 2230 solid-state drive
Steps
1. Remove the screw (M2x2) to secures the M.2 2230 solid-state drive holder to the system board.
2. Lift the M.2 2230 solid-state drive holder off the palm-rest and keyboard assembly.
3. Flip the M.2 2230 solid-state drive holder and remove the single screw (M2x2) that secure the M.2 2230 solid-state drive to
the M.2 2230 solid-state drive holder.
4. Remove the M.2 2230 solid-state drive.
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the M.2 2230 solid-state drive and provide a visual representation of the
installation procedure.
48
Removing and installing Customer Replaceable Units (CRUs)