Installing the eDP cable
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the eDP cable and provides a visual representation of the installation procedure.
Figure 67. Installing the eDP cable
Steps
1. Connect the eDP cable to the connector on the camera module.
2. Adhere the eDP cable to the display back cover.
3. Adhere the conductive tape and route the eDP cable to the display back cover.
Next steps
1. Install the camera.
2. Install the display panel.
3. Install the display bezel.
4. Install the display assembly.
5. Install the base cover.
6. Follow the procedure in After working inside your computer.
96
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
