About this task
The following image shows the display bezel and provide a visual representation of the removal procedure.
Figure 52. Removing the display bezel
Steps
NOTE:
The display bezel is adhered to the display panel with adhesive. Insert a plastic scribe into the recesses near both
hinge caps to start the prying process to release the display bezel. Pry along the outside edge of the display bezel and work
your way around the entire display bezel until the display bezel is separated from the display cover.
CAUTION: Carefully pry and remove the display bezel to minimize the risk of display panel damages.
1. Using a plastic scribe, pry open the recesses near the left and right hinges on the bottom edge of the display bezel.
2. Carefully work your way around the edges of the display bezel to release it from the display back cover.
3. Lift the display bezel from the display assembly.
NOTE:
The display bezel is a consumable part and should be replaced with a new display bezel anytime it is removed
from the system.
Installing the display bezel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display bezel and provides a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
83
To Next Page
Loading...
