Installing battery
1. Route the battery cable through the routing clip and connect the battery cable to the connector on the system board.
NOTE: Route the battery cable, if the cable at the base of the battery is un routed.
2. Insert the lower edge of the battery into the slot on the chassis and then seat the battery.
3. Tighten the two (M2.0 x 5.0) screws to secure the battery to the system.
NOTE: A small battery (3-cell) has a single screw, a larger battery (4-cell) has two screws.
4. Install the base cover
5. Follow the procedure in After working inside your computer.
Solid state drive
Removing Solid State Drive
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Disconnect the battery cable from the connector on the system board.
4. To remove the Solid State Drive:
a. Loosen the two (M2.0 x 3.0) captive screws that secure the Solid State Drive bracket [1].
b. Remove the Solid State Drive bracket (optional) [2].
c. Remove the Solid State Drive from the system [3].
16 Removing and installing components
To Next Page
Loading...
