NOTE: The touchpad buttons board cable is below the smart card cable.
b. Remove the two (M2.0 x 3.0) screws that secure the touchpad buttons board [2].
NOTE: To identify the screws, see screw list.
c. Lift the touchpad buttons board from the system [3].
Installing touchpad buttons board
1. Insert the touchpad buttons board into the slot to align the tabs with the grooves on the system.
2. Replace the two (M2.0 x 3.0) screws to secure the touchpad buttons board to the system.
3. Connect the touchpad buttons board cable to the connector on the touchpad board.
4. Install the smart card module.
5. Install the speaker.
6. Connect the battery cable to the connector on the system board.
7. Install the base cover.
8. Follow the procedure in After working inside your computer.
Power connector port
Removing power connector port
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
28 Removing and installing components
To Next Page
Loading...
