Dell Latitude 7490 - POST behavior screen options

Option Description
● Disabled
● WLAN
Default setting: Disabled
Block Sleep This option lets you block entering to sleep (S3 state) in operating system environment.
Block Sleep (S3 state)
Default setting: This option is disabled
Peak Shift This option enables you to minimize the AC power consumption during the peak power times of day. After
you enable this option, your system runs only in battery even if the AC is attached.
● Enable peak shift
● Set battery threshold (15% to 100%) - 15 % (enabled by default)
● Enable peak shift—is disabled
● Set battery threshold (15% to 100%) - 15 % (enabled by default)
Advanced
Battery Charge
Configuration
This option enables you to maximize the battery health. By enabling this option, your system uses the
standard charging algorithm and other techniques, during the nonwork hours to improve the battery
health.
Disabled
Default setting: Disabled
Primary
Battery Charge
Configuration
Allows you to select the charging mode for the battery. The options are:
● Adaptive—enabled by default
● Standard—Fully charges your battery at a standard rate.
● ExpressCharge—The battery charges over a shorter time using Dell’s fast charging technology This
option is enabled by default.
● Primarily AC use
● Custom
If Custom Charge is selected, you can also configure Custom Charge Start and Custom Charge Stop.
NOTE: All charging mode may not be available for all the batteries. To enable this option, disable the
Advanced Battery Charge Configuration option.
Sleep mode
● OS Automatic selection—enabled by default
Force S3
Type-C
connector power
● 7.5 Watts
● 15 Watts—enabled by default
POST behavior screen options
Option Description
Adapter
Warnings
Allows you to enable or disable the system setup (BIOS) warning messages when you use certain power
adapters.
Default setting: Enable Adapter Warnings
Keypad
(Embedded)
Allows you to choose one of two methods to enable the keypad that is embedded in the internal keyboard.
● Fn Key Only—default.
● By Numlock
NOTE: When setup is running, this option has no effect. Setup works in Fn Key Only mode.
Numlock Enable Allows you to enable the Numlock option when the computer boots.
Enable Network. This option is enabled by default.
Fn Key Emulation Allows you to set the option where the Scroll Lock key is used to simulate the Fn key feature.
72 System setup