4. Install the WLAN card.
5. Install the WWAN card.
6. Connect the battery cable to the connector on the system board.
7. Install the base cover.
8. Follow the procedure in After working inside your computer.
Nontouch display panel
Removing the display panel (nontouch)
NOTE: The display panel removal procedure is applicable only for nontouch display configuration.
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Disconnect the battery cable from the connector on the system board.
4. Remove the WLAN card.
5. Remove the WWAN card.
6. Remove the display assembly.
7. Remove the display bezel.
8. Remove the hinge caps.
9. To remove the display panel:
a. Remove the two (M2.0 x 2.0) screws on the panel [1].
b. Lift the bottom edge of the display panel [2].
c. Slide the display panel away from the system from the bottom [1], and flip the display panel over [2].
Removing and installing components 35
To Next Page
Loading...
