3. Disconnect the battery cable from the connector on the system board.
4. To remove the power connector port:
a. Disconnect the power connector port cable from the system board [1].
NOTE: Use a plastic scribe to release the cable from the connector. Do not pull the cable as it may result in
breakage.
b. Remove the M2.0 x 3.0 screw to release the metal bracket on the power connector port [2].
c. Lift the metal bracket from the system [3].
d. Remove the power connector port from the computer [4].
Installing power connector port
1. Install the power connector port into the slot on the system.
2. Place the metal bracket on the power connector port.
3. Replace the M2.0 x 3.0 screw to secure the power connector port to the system.
4. Connect the power connector port cable to the connector on the system board.
5. Connect the battery cable to the connector on the system board.
6. Install the base cover.
7. Follow the procedure in After working inside your computer.
Display Assembly
Removing display assembly
1. Follow the procedure in Before working inside your computer.
Removing and installing components 29
To Next Page
Loading...
