System Configuration
• Disabled
• Level is 25%
• Level is 50%
• Level is 50%
• Levels is 100%
Default Setting: Level is 75%
Drives Allows you to configure the SATA drives on board. The options are:
• SATA-0
• SATA-1
• SATA-4
• SATA-5
Default Setting: All drives are enabled.
Video
LCD Brightness Allows you to set the display brightness depending up on the power source (On
Battery and On AC).
NOTE: The Video setting will only be visible when a video card is installed into the system.
Security
Admin Password Allows you to set, change, or delete the administrator (admin) password.
NOTE: You must set the admin password before you set the system or hard
drive password.
NOTE: Successful password changes take effect immediately.
NOTE: Deleting the admin password automatically deletes the system
password and the hard drive password.
NOTE: Successful password changes take effect immediately.
Default Setting: Not set
System Password Allows you to set, change or delete the system password.
NOTE: Successful password changes take effect immediately.
Default Setting: Not set
Internal HDD-0 Password Allows you to set or change the system's internal hard-disk drive.
NOTE: Successful password changes take effect immediately.
Default Setting: Not set
Password Bypass Allows you to enable or disable the permission to bypass the System and the
Internal HDD password, when they are set. The options are:
• Disabled
• Reboot bypass
104
To Next Page
Loading...
