Upgrade Dell EMC Networking N1500 Series Switches
Page 12
Boot Main Menu
==============
1 - Start Operational Code
2 - Select Baud Rate
3 - Retrieve Logs
4 - Load New Operational Code
5 - Display Operational Code Details
9 - Reboot
10 - Restore Configuration to Factory Defaults
11 - Activate Backup Image
12 - Start Password Recovery
4. Download the firmware to the switch using TFTP (Select option 4 - Load new operational code). Skip this step
if firmware is already loaded on switch.
Boot Main Menu
==============
1 - Start Operational Code
2 - Select Baud Rate
3 - Retrieve Logs
4 - Load New Operational Code
5 - Display Operational Code Details
9 - Reboot
10 - Restore Configuration to Factory Defaults
11 - Activate Backup Image
12 - Start Password Recovery
Enter Choice# 4
Creating tmpfs filesystem on /mnt/download for download...done.
Current Active Image# /dev/mtd7
Which Image to Update Active (/dev/mtd7) OR Back-Up (/dev/mtd6)? Select (A/B): A
You selected to update Active Image /dev/mtd7...
Select Mode of Transfer (Press T/X/Y/Z for TFTP/XMODEM/YMODEM/ZMODEM) []:T
Please ensure TFTP server is running to begin Transfer...
Enter Server IP []:10.10.10.200
Enter Host IP []:10.10.10.224
Enter Host Subnet Mask [255.255.255.0]:255.255.0.0
Enter Gateway IP []:10.10.10.254
Enter Filename []:N1500v6.5.2.9.stk
Do you want to continue? Press(Y/N): y
Bringing up eth0 interface...done.
Adding default gateway 10.10.10.254 to the Routing Table...done.
Erasing /dev/mtd7!!!
Erasing 128 Kibyte @ 17e0000 -- 99 % complete.
Updating code file...done.
Code Update Instructions Found!
Critical components modified on Active Partition -- System Reboot Recommended!
Reboot? (Y/N): y
Rebooting...
starting pid 11
syncing filesystems....This may take a few moments
Rebooting system!
Reference platform resetting ...
starting pid 17Rebooting system!
To Next Page
Loading...
Need help?
General
