198 Managing a Switch Stack
2
Preconfigure the switch (SID = 2) as member number 2 in the stack.
console#configure
console(config)#stack
console(config-stack)#member 2 2
console(config-stack)#exit
console(config)#exit
3
Confirm the stack configuration. Some of the fields have been omitted
from the following output due to space limitations.
console#show switch
Management Standby Preconfig Plugged-in Switch Code
SW Status Status Model ID Model ID Status Version
--- ---------- --------- ------------- ------------- ------------- -----------
1 Mgmt Sw N3048 N3048 OK 6.0.0.0
To Next Page
Loading...
