Dell N3000 Series - Configuring L2 Multicast Features (Web); Multicast Global Parameters

816 Configuring L2 Multicast Features
Configuring L2 Multicast Features (Web)
This section provides information about the OpenManage Switch
Administrator pages for configuring and monitoring L2 multicast features on
a Dell Networking N2000, N3000, and N4000 series switches. For details
about the fields on a page, click at the top of the page.
Multicast Global Parameters
Use the Multicast Global Parameters page to enable or disable IGMP
snooping, or MLD snooping on the switch.
To display the Multicast Global Parameters page, click Switching
→
Multicast Support
→ Global Parameters in the navigation menu.
Figure 25-1. Multicast Global Parameters
NOTE: It is strongly recommended that users enable IGMP snooping if MLD
snooping is enabled and vice-versa. This is because both IGMP snooping and
MLD snooping utilize the same forwarding table, and not enabling both may
cause unwanted pruning of protocol packets utilized by other protocols, e.g.
OSPFv2.