8 System Firmware Version 5.1.0.1
Release 4.2.1.3
No Added Functionality in this Release
Release 4.2.0.4
DCBx on M8024-k/8024/8024F
FIP Snooping Bridge on M8024-k/8024/8024F
Add EEE Support for the PC7000 10GBaseT Ports
GUI EEE Power Savings Charts
RP Failover Performance Improvement
Flexible Dynamic LAG Limits
CLI Help Usability Improvements
Ability to Show Static Route Entries
CMC XML Support
Stacking Over Ethernet Ports
Change Dell EqualLogic iSCSI Auto Detect to default
Add CLI Macro (Port Profile) for Dell Compellent Storage Equipment
Provide Dell EqualLogic DCBx TLV Auto Detect and Configuration on M8024-k/8024/8024F
Release 4.1.1.9
No Added Functionality in this Release
Release 4.1.0.19
Media-type CLI command
Added new command "media-type" to configure an interface to select the specified media on a combo port. It is
recommended the administrators select the specific media type for the particular type of network connection they
expect to use. Users may observe a single port flap when the media type is changed from RJ45 to auto-select RJ45 and
only the corresponding SFP port is enabled. Refer to the CLI Reference Guide Updates section below for the complete
syntax.
Release 4.1.0.6
IPv4-Only Mode Optimization
PowerConnect switches allocate the maximum sizes for routing tables (and others, as applicable) for both IPv4 and
IPv6. Switch Performance Optimization allows the operator to optimize the allocation of switch silicon tables for
either IPv4 only or mixed IPv4/IPv6 operation. The template specified limits are enforced by routing components
when routes are being learned. When IPv4 only mode is selected, the following capabilities are disabled:
• DHCPv6 relay
• DHCPv6 server
• IPv6 routing/forwarding
• OSPFv3
• IPv6 Neighbor Discovery
• Configured v6-over-v4 tunnels
• Automatic (6to4) tunnels
• IPv6 Multicast
A reboot is required when changing to or from IPv4 mode.
To Next Page
Loading...
