Dell Networking 7048 - Management - 4.2.0.4

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
System Firmware Version 5.1.0.1 Page 71
system automatically adjust the IPv4/ IPv6 MTU based on the link MTU.
VRRP
Description
User Impact
The maximum number of VRRP
instances is 50.
Users can scale VRRP higher than previously.
Management – 4.2.0.4
CLI
Description
User Impact
radius-server mode commands do not
have a "no" form.
Low - None of the commands in radius-server mode support a "no" form except
for the msgauth command. To reset values to the default, delete the server entry
and add it back.
The maximum command line length is
1536 characters.
Low - Entries greater than the maximum line length throw an error, e.g. using
multiple interface range qualifiers.
USB
Description
User Impact
Dir command can only address top-level
directory on USB stick
Minimal – users can move files to top-level directory easily
Only FAT32 formatted devices are
supported.
Minimal – FAT32 devices are the de-facto standard for flash devices
When multiple partitions are present on
the flash drive, only the first partition is
accessible.
Minimal – users will typically re-partition flash drives to maximize space.
Web
Description User Impact
Certain browser (IE) versions respond
slowly when displaying large lists of
information. In these cases, the “All”
display selection may not appear (is
disabled).
This behavior is a browser performance limitation. Users may select another
supported browser to enable “all” display functionality. Alternatively, the user
may utilize the page selector functions to display the appropriate page of
information.
Certain browser (FireFox) versions
automatically block popups after a
certain number of displays within a
session.
This behavior is a browser functionality issue. If popups are blocked, the web
interface will display errors/information using alerts. Users can disable popup
monitoring by browsing to about:config and set dom.popup_maximum to -1
File Management
Description User Impact
CLI Comment Character The '!' indicates the beginning of a comment. All characters following the '!' will
be treated as a comment (except when configuring a banner where the ! is
accepted at the beginning of a line)