Dell Networking 7048 - Page 30

28 System Firmware Version 5.1.0.1
Release 4.2.2.3
general mode
vlan does not
show up after a
reload, it shows
up in access
vlan
The general mode for switchport won't
work properly in several cases, such as,
script apply, nsf failover and save and
reload.
Corrected memory
initialization problem
All
SNMP OIDs
1.3.6.1.4.1.674.1
0895.3000.1.2.1
10.7.x causing
switch crash
Walk of any member of
envMonFanStatusEntry and
envMonSupplyStatusEntry with 67109251
index causes crash.
Corrected unit number range
check.
All
Stack ARP
Problem
ARP replies to a routing interface are not
received at the CPU after clearing the
config and reconfiguring the routing
interfaces.
Corrected ARP reply policy
problem
All
Stack member
units port
display is
missing in web
GUI.
Stack member unit ports were not displayed
properly.
Corrected power LED element
id name problem which was
causing this display problem.
PCM8024-K
No response to
ICMP with
jumbo (ping)
Third IP fragment was being dropped in
jumbo Ping packet.
Corrected jumbo Ping packet
problem.
All
Ports connected
to Intel X520
NIC do not
return online
after reboot.
When customer is using the Intel X520
NICs, sometimes the ports never came back
up after a reboot of the switch.
Corrected port configuration
timing issue.
PC8024
PC8024F
switch reboots
randomly
switch reboots randomly
Corrected memory corruption
problem.
All
Summary
User Impact
Resolution
Affected Platforms
IP routing
unexpectedly
after reboot
despite its not
having been
enabled.
Traffic will get forwarded by software when
global routing is not enabled.
Correct the default action so
that global forwarding is
enabled for the hardware.
All 4.2 supported
platforms
Telnet existing
session is
interrupted
when "New
Telnet Sessions"
is set to "Block".
"New Telnet Sessions" are changed to
Block, All the current telnet sessions are
closed and using "Telnet Server Admin
Mode" to set Disable will only block new
telnet sessions.
Functionality was corrected so
that "New Telnet Sessions"
will only block new telnet
sessions and "Telnet Server
Admin Mode" will close all
the sessions if the mode is
Disabled.
All 4.2 supported
platforms
OOB interface
unreachable
after failover
Out-Of-Band interface will be unreachable
after a stack failover
Corrected MAC address for
new manager.
PCM6220
PCM6348
PCM8024
PCM8024-k
Switch CLI help
does not locate
the 'initiate
failover'
command
properly
Warning message printed during execution
of the deprecated "movemanagement"
command incorrectly
states that "initiate failover" command is
executed from privileged EXEC mode
whereas it's available from stack config
mode only.
Corrected the warning message All 4.2 supported
platforms