Dell Networking 7048 - Page 39

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
System Firmware Version 5.1.0.1 Page 37
M8024 - 1GB
link being
negotiated on
10GB Intel
X520-KX4
The M8024 is negotiating 1GB speed
connection with the 10GB X520-KX4 Intel
card in the blade server. Issue is only
present with new
Incorrect pre-emphasis values
have been corrected.
PCM8024
Feature request -
Display "client-
DUID" in
DHCP binding
table.
The "Client-DUID" is used to uniquely
identify an individual host receiving DHCP
address configuration.
In the case of a multi-homed host, it is
possible to determine that the host has
multiple bindings for different interfaces
and which interfaces belong to each host.
Client-DUID parameter has
been added to show "ip dhcp
binding" command output.
All 4.2 supported
platforms
clock summer-
time recurring
EU offset 60
zone "GMT" not
offsetting the
time by 60
minutes
Time change offset is applied early.
Day of month calculation has
been corrected.
All 4.2 supported
platforms
M6220 - Simple
mode, VLAN
setting not
active when
move port to
another group
Modular switch in Simple mode. Interfaces
have VLAN settings different from default.
If you move port from one aggregation
group to another, VLAN settings are
retained and are listed in running config but
it is not active until system is rebooted or
VLAN information removed and reentered
again.
None – issue corrected
All 4.2 supported
platforms
SSH
configuration
not restored
after reboot
SSH config is not restored after reboot.
ssh configuration saved
All 4.2 supported
platforms
PC8024 -
VLAN trunk
assignment CLI
change
On 4.1.0.6 if VLANS are assigned to a
trunk, the switch CLI will display the
VLANS not assigned instead of the VLANS
that are assigned
VLANs are displayed in
positive format, i.e. assigned
VLANs are displayed.
All 4.2 supported
platforms
Web UI displays
incorrect session
timeout duration
After the browser session timeout (default
10 minutes), Web UI displays incorrect
session timeout duration in the message
"Your session had been inactive for more
than 240 minutes
The displayed message was
corrected.
All 4.2 supported
platforms
PC8024 - Secure
HTTP Random
Characters -
4.1.0.6
If you go to system management, Secure
HTTP, you will see random characters
populating the fields. Even if you delete
these entries and re-populate with valid
chars, it will repopulate with invalid
characters making it impossible to generate
a cert using the web interface.
The random character
rendering has been corrected.
All 4.2 supported
platforms
Upgrades to
4.1.0.9 are
causing network
outages. The
wizard from
4.1.0.9 fails to
setup interfaces
The wizard in 4.1.0.9 fails to create any or
very few interfaces and there was no config
for any or very few of the ports, thus, the ip,
icmp traffic was not working between ports
as well.
Issue with switch upgrade has
been resolved.
All 4.2 supported
platforms