Dell OptiPlex 3000 Small Form Factor - Solid-State Drive (M.2)

Steps
1. Slide the optical drive into the disk-drive cage until it snaps into place.
2. Install the single (M2x3) screw to secure the optical drive to the disk-drive cage.
Next steps
1. Install the disk-drive cage.
2. Install the 3.5-inch hard-drive.
3. Install the 2.5-inch hard-drive.
4. Install the front bezel.
5. Install the side cover.
6. Follow the procedure in after working inside your computer.
Solid-state drive
Removing the M.2 2230 PCIe solid-state drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard-drive.
5. Remove the 3.5-inch hard-drive.
6. Remove the hard-drive and optical-drive cage.
About this task
The following images indicate the location of the M.2 2230 PCIe solid-state drive and provide a visual representation of the
removal procedure.
Removing and installing components
35