3. Remove the front bezel.
4. Remove the 2.5-inch hard-drive.
5. Remove the 3.5-inch hard-drive.
6. Remove the disk-drive cage.
About this task
The following images indicate the location of the bay-support bracket and provide a visual representation of the removal
procedure.
Steps
1. Remove the two (#6-32) screws that secures the bay-support bracket to the chassis.
2. Push the bay-support bracket to free it from the front side of the chassis.
3. Lift and remove the bay-support bracket from the system.
Installing the bay-support bracket
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the bay-support bracket and provides a visual representation of the installation
procedure.
Removing and installing components
39
To Next Page
Loading...
