Steps
1. Place the processor fan and heat-sink assembly on the system board and align the captive screws to the screw holes on the
system board.
2. Tighten the four captive screws that secure the heat stink to the system board.
3. Connect the processor-fan cable to the system board.
Next steps
1. Install the disk-drive cage.
2. Install the front bezel.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Processor
Removing the processor
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the 2.5-inch hard-drive.
4. Remove the 3.5-inch hard-drive.
5. Remove the heat-sink and fan assembly.
6. Remove the disk-drive cage.
NOTE:
The processor may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
About this task
The following images indicate the location of the processor and provide a visual representation of the removal procedure.
Removing and installing components
55
To Next Page
Loading...
