Steps
1. Insert the PS2 module into its slot on the chassis.
2. Connect the PS2-module cable to the connector on the system board.
3. Close the expansion-card door, and press until it clicks into place.
Next steps
1. Install the heat-sink and fan assembly.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Optional I/O modules (VGA/HDMI/DP)
Removing optional I/O module
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the heat-sink and fan assembly.
About this task
The following images indicate the location of the optional I/O module and provides a visual representation of the removal
procedure.
NOTE: The removal procedure for the VGA/DP/HDMI optional I/O modules are the same.
Steps
1. Remove the two screws that secure the I/O module to the chassis.
64
Removing and installing components
To Next Page
Loading...
