Steps
1.
NOTE: The Dell Ultra Speed Drive Gen4 card must be installed in the PCIe x4 slot.
Align the Dell Ultra Speed Drive Gen 4 card with the PCIe x4 card slot on the system board.
2. Using the alignment post, connect the card in the connector and press down firmly.
3. Ensure that the card is firmly seated.
4. Close the expansion-card door, and press until it clicks into place.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Optional I/O modules (PS2/Serial)
Removing PS2 module
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the heat-sink and fan assembly.
About this task
The following images indicate the location of the PS2 module and provides a visual representation of the removal procedure.
Removing and installing components
61
To Next Page
Loading...
