Steps
1. Align and place the bay-support bracket on the slot on the chassis.
2. Replace the two (#6-32) screws that secures the bay-support bracket to the chassis.
Next steps
1. Install the disk-drive cage.
2. Install the 3.5-inch hard-drive.
3. Install the 2.5-inch hard-drive.
4. Install the front bezel.
5. Install the side cover.
6. Follow the procedure in after working inside your computer.
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the 2.5-inch hard-drive.
4. Remove the 3.5-inch hard-drive.
5. Remove the disk-drive cage.
40
Removing and installing components
To Next Page
Loading...
