2. Slide the side cover towards the back of the computer to engage the tabs on the side cover with the slots on the chassis.
3. Tighten the thumbscrew (6-32) to secure the side cover to the chassis.
Next steps
1. Follow the procedure in after working inside your computer.
Speaker
Removing the speaker
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
About this task
The following image indicates the location of the speaker and provides a visual representation of the removal procedure.
Steps
1. Disconnect the speaker cable from the connector on the system board.
2. Unroute the speaker cable from the routing guides on the chassis.
3. Press the release tab to release the speaker from the slot on the chassis.
4. Lift and remove the speaker from the chassis.
Installing the speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
14
Removing and installing components
To Next Page
Loading...
