Steps
1. Remove the two screws (M3X3) that secure the PS/2 keyboard/mouse module to the chassis.
2. Slide and lift the PS/2 keyboard/mouse module off the chassis.
3. Disconnect the three PS/2 keyboard/mouse module cables from the connectors on the system board.
4. Remove the PS/2 keyboard/mouse module with the cables off the chassis.
Installing the optional PS/2 keyboard/mouse module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the optional PS/2 keyboard/mouse module and provides a visual representation of
the installation procedure.
To identify the ports and connectors, see the system board connectors.
Steps
1. Insert and push the flat-head screwdriver into the slot on the optional module filler to release the optional module filler from
the chassis.
NOTE:
Step one is only applicable for new installation or component upgrade. For replacing an existing component,
follow the procedure from step two.
2. Insert the PS/2 keyboard/mouse module into the optional I/O module slot on the chassis.
3. Connect the three PS/2 keyboard/mouse module cables to the connectors on the system board.
4. Replace the two screws (M3X3) to secure the PS/2 keyboard/mouse module to the chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
30
Removing and installing components
To Next Page
Loading...
