Optional modules
Removing the optional Type-C module
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
About this task
The following image indicates the location of the optional Type-C module and provides a visual representation of the removal
procedure.
To identify the ports and connectors, see the system board connectors.
Steps
1. Remove the two screws (M3x3) that secure the Type-C module to the chassis.
2. Slide and rotate the Type-C module.
3. Disconnect the Type-C cable and the DisplayPort cable from the connectors on the system board.
4. Lift the Type-C module and the cables off the chassis.
Installing the optional Type-C module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the optional Type-C module and provides a visual representation of the installation
procedure.
To identify the ports and connectors, see the system board connectors.
24
Removing and installing components
To Next Page
Loading...
