Steps
1. Align the screws on the heat sink with the screw holders on the system board and place the heat sink on the processor.
2. In sequential order (as indicated by the numbers on the heat sink), tighten the four captive screws that secure the heat sink
to the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Internal Antenna
Removing the internal antenna in Location 1
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the WLAN card.
About this task
The following image indicates the location of an internal antenna in location 1 and provides a visual representation of the removal
procedure.
34
Removing and installing components
To Next Page
Loading...
