3. Insert the antenna cable through the opening at the back of the system.
4. Route the antenna-cable through cable clip and the routing guides on the chassis.
5. Tilt and align the tab on the antenna with the slot on the chassis.
6. Replace the screw (M3x3) to secure the antenna to the chassis.
7. Place the antenna cover on the antenna and tighten the captive screw to secure the antenna.
Next steps
1. Install the WLAN card.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
SMA Antenna
Removing the SMA antenna in Location 2
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the WLAN card.
About this task
The following image indicates the location of the SMA antenna and provides a visual representation of the removal procedure.
NOTE: To upgrade to SMA antenna, the internal antenna Location 2 is required to be removed.
40 Removing and installing components
To Next Page
Loading...
