5. Flex the hard-drive bracket and then remove the hard drive from the bracket.
6. Repeat the above steps for the second hard drive, if available.
Related Links
Installing the Hard Drive
Installing The Hard Drive
1. Flex the hard-drive bracket and then insert the hard drive into the bracket.
2. Press both blue securing-bracket tabs inward and slide the hard-drive bracket into the bay in the chassis.
3. Connect the data cable and power cable to the back of the hard drive.
4. Install the cover.
5. Follow the procedures in After Working Inside Your Computer.
Related Links
Removing the Hard Drive
Removing the Memory
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the cover.
3. Release the memory-retention clips on each side of the memory modules.
14
To Next Page
Loading...
