Dell OptiPlex 3010 Mini-Tower - Installing the Power-Switch Cable; Removing the Front Thermal Sensor

Related Links
Installing the Power Switch Cable
Installing the Power-Switch Cable
1. Slide the power-switch cable in through the front of the computer.
2. Secure the power-switch cable to the chassis.
3. Thread the power-switch cable into the chassis clips.
4. Connect the power-switch cable to the system board.
5. Install the optical drive.
6. Install the front bezel.
7. Install the cover.
8. Follow the procedures in After Working Inside Your Computer.
Related Links
Removing the Power Switch Cable
Removing the Front Thermal Sensor
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the cover.
3. Disconnect the thermal-sensor cable from the system board.
4. Unthread the thermal-sensor cable from the chassis clip.
22