Dell OptiPlex 3010 Mini-Tower - Removing the Front Bezel; Installing the Front Bezel; Removing the Expansion Card

Removing the Front Bezel
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the cover.
3. Pry the front bezel retention clips away from the chassis located at the side edge of front bezel.
4.
Rotate the bezel away from the computer to release the hooks on the opposite edge of the bezel from the chassis.
Related Links
Installing the Front Bezel
Installing The Front Bezel
1. Insert the hooks along the bottom edge of the front bezel into the slots on the chassis front.
2. Rotate the bezel toward the computer to engage the four front-bezel retention clips until they click into place.
3. Install the cover.
4. Follow the procedures in After Working Inside Your Computer.
Related Links
Removing the Front Bezel
Removing the Expansion Card
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the cover.
3. Push the release tab on the card-retention latch outward.
10