Dell OptiPlex 3046 - Mini Tower - Installing the Optical Drive (3.5-Inch); Removing the SD Card Reader

Installing the optical drive (3.5-inch)
1 Insert the optical drive into the optical drive bay until it clicks into place.
2 Connect the data cable and power cable to the connectors on the optical drive.
3 Install the:
• bezel
• cover
4 Follow the procedure in After Working Inside Your Computer.
Removing the SD card reader
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the:
• cover
• bezel
3 Open the front bezel door.
4 To remove the SD card reader:
a Disconnect the SD card reader cable from the connector on the system board [1].
b Remove the screw that secures the SD card reader to the computer [2].
c Lift the SD card reader out of the computer [3].
Removing and installing components 11