Dell OptiPlex 3046 - Mini Tower - Installing the SD Card Reader; Removing the Memory Module; Installing the Memory Module

Installing the SD card reader
1 Insert the SD card reader into the slot on the system board.
2 Tighten the screw to secure the SD card reader to the system board
3 Connect the SD card reader cable to the connector on the system board.
4 Close the front bezel door.
5 Install the:
a bezel
b cover
6 Follow the procedure in After Working Inside Your Computer.
Removing the memory module
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the:
• cover
• bezel
3 Open the front bezel door.
4 To remove the memory module:
a Press the memory module retention tabs on both sides of the memory module.
b Lift the memory module from the memory module connector on the system board.
Installing the memory module
1 Align the notch on the memory module with the tab on the memory module connector.
2 Insert the memory module into the memory module socket.
3 Press the memory module until the memory module retention tabs click into place.
Removing and installing components 12