Installing the processor
1 Align the processor with the socket keys.
2 Align the pin-1 indicator of the processor with the triangle on the socket.
3 Place the processor on the socket such that the slots on the processor align with the socket keys.
4 Close the processor shield by sliding it under the retention screw.
5 Lower the socket lever and push it under the tab to lock it.
6 Install the:
a heat sink
b fan duct
c optical drive
d hard drive assembly
e front bezel
f cover
7 Follow the procedure in After Working Inside Your Computer.
Removing the VGA daughter board
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the:
a cover
b fan duct
3 To remove the VGA daughter board:
a Remove the screws that secure the VGA connector to the computer [1].
b Slide the VGA connector to release it from the computer [2].
c Remove the screw that secures the VGA daughter board to the computer [3].
d Lift the VGA daughter board using the handle to remove it from the computer [4].
Removing and installing components 16
To Next Page
Loading...
