Removing the power switch
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the:
a cover
b front bezel
c hard drive assembly
d optical drive
e power supply unit
3 To remove the power switch:
a Disconnect the power switch cable from the system board [1].
b Press the power switch retention tabs and remove it from the chassis [2] [3].
Installing the power switch
1 Slide the power switch module into the slot on the chassis until it clicks into place.
2 Connect the power switch cable to the connector on the system board.
3 Install the:
a power supply unit
b optical drive
c hard drive assembly
d front bezel
e cover
4 Follow the procedure in After Working Inside Your Computer.
Removing the SD card reader
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the:
a cover
b front bezel
c hard drive assembly
d optical drive
e power supply unit
3 To remove the SD card reader:
a Remove the power supply unit cables from the retention clips on the SD card reader enclosure [1].
Removing and installing components 19
To Next Page
Loading...
