Option Description
Password Bypass This option lets you bypass the System (Boot) Password and the internal HDD password
prompts during a system restart.
• Disabled — Always prompt for the system and internal HDD password when they are set.
This option is disabled by default.
• Reboot Bypass — Bypass the password prompts on Restarts (warm boots).
NOTE: The system will always prompt for the system and internal HDD passwords
when powered on from the off state (a cold boot). Also, the system will always prompt
for passwords on any module bay HDDs that may be present.
Password Change This option lets you determine whether changes to the System and Hard Disk passwords are
permitted when an administrator password is set.
Allow Non-Admin Password Changes - This option is enabled by default.
TPM 1.2 Security Allows you to control whether the Trusted Platform Module (TPM) is visible to the operating
system.
• TPM On (default)
• Clear
• PPI Bypass for Enable Commands
• PPI Bypass for Disable Commands
• Disabled
• Enabled (default)
Computrace This field lets you Activate or Disable the BIOS module interface of the optional Computrace
Service from Absolute Software. Enables or disables the optional Computrace service
designed for asset management.
• Deactivate - This option is disabled by default.
• Disable
• Activate
Chassis Intrusion Allows you to control the chassis intrusion feature. You can set this option to:
• Enable
• Disable
• On-Silent — Enabled by default if chassis intrusion is detected.
CPU XD Support Allows you to enable or disable the Execute Disable mode of the processor. This option is
enabled by default.
OROM Keyboard Access This option determines whether users are able to enter Option ROM Configuration screens
via hotkeys during boot. Specifically, these settings are capable of preventing access to Intel
RAID (CTRL+I) or Intel Management Engine BIOS Extension (CTRL+P/F12)
• Enable — User may enter OROM configuration screens via the hotkey.
• One-Time Enable — User may enter OROM configuration screens via the hotkeys on
next boot only. After next boot, the setting will revert to disabled.
• Disable — User may not enter OROM configuration screens via the hotkey.
This option is set to Enable by default.
Admin Setup Lockout Allows you to enable or disable the option to enter Setup when an Administrative password
is set. This option is not set by default.
HDD Protection Support Allows you to enable or disable the HDD Protection feature. This option is an advanced
feature, which is intended to keep the HDD data secure and unchangeable. By default, this
option is disabled.
System Setup 33
To Next Page
Loading...
