Dell OptiPlex 3050 Micro - Installing 2.5-Inch Drive Assembly; WLAN Card; Removing the WLAN Card

Installing 2.5–inch drive assembly
Steps
1. Insert the drive assembly into the slot on the computer.
2. Slide the drive assembly toward the connector until it clicks into place.
3. Install the cover.
4. Follow the procedure in After working inside your computer.
WLAN card
Removing the WLAN card
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. cover
b. hard drive assembly
3. To remove the WLAN card:
a. Remove the screw that secures the plastic tab [1].
b. Release the plastic tab to access the WLAN cables [2].
c. Disconnect the WLAN cables from the connectors on the WLAN card [3].
d. Lift the WLAN card from the connector on the system board [4].
Removing and installing components
15