Dell OptiPlex 3050 Micro - Installing the WLAN Card; Pcie SSD; Removing the M.2 Pcie SSD

Installing the WLAN card
Steps
1. Insert the WLAN card to the connector.
2. Connect the WLAN cables to the WLAN card.
3. Place the plastic tab to secure the WLAN cables.
4. Tighten the screw to secure the plastic tab to the WLAN card.
5. Install the:
a. hard drive assembly
b. cover
6. Follow the procedure in After working inside your computer.
M.2 PCIe SSD
Removing the M.2 PCIe SSD
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. cover
b. 2.5–inch drive assembly
3. To remove the M.2 PCIe SSD:
a. Remove the screw that secures the M.2 PCIe SSD [1].
b. Lift and pull out the PCIe SSD from its connector [2].
16
Removing and installing components